Downloads

HinriMill Updates

Before installing the firmware please contact our support.

Updating the firmware of the CNC machine

The firmware is the internal control software of your CNC machine. New versions may introduce new functions and improve existing ones. You receive new firmware versions on the following ways:

• Together with new versions of DentalCNC.
  Obtain them regularly.

Damaging of the control unit when a firmware update is interrupted

If the firmware update is interrupted, for example by a power outage, by disconnecting the USB connection between the computer and the CNC machine, by closing  DentalCNC etc., the control unit of the machine may take permanent damage.

• Only update the firmware when a permanent electrical supply of the machine and the computer is guaranteed.
• Only update the firmware if the computer runs stably and is free of malware.
• Do not disconnect the CNC machine or the computer from the electrical source and do not switch off the machine or the computer during an update.
• Do not close DentalCNC during an update.

In the following you find the current setup file in ZIP format for our software HinriMill.

HinriMill 4 Software

Update HinriMill 4, Version: 4.2.4

HinriMill 5 & 5.8 / HinriMill N4 / HinriMill T5 / HinriMill T5X Software

DentalCAM 6

- Update HinriMill 5 & 5.8 / HinriMill N4, HinriMill T5, Version: 6.17.00

DentalCAM 7

- Update HinriMill 5 & 5.8 / HinriMill N4, HinriMill T5 & T5X / HinriMill R5, Version: 7.08.00.P16

DentalCAM 8

- Update HinriMill 5 & 5.8 / HinriMill N4, HinriMill T5 & T5X / HinriMill R5, Version: 8.10.00.P3

Stand: 15.10.2024

Installation: